DTC P0082 Intake Valve Control Solenoid Circuit Low (Bank 2)
WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.
DTC DETECTING CONDITION:
- Immediately at fault recognition
- GENERAL DESCRIPTION < Ref. to DTC P0082 INTAKE VALVE CONTROL SOLENOID CIRCUIT LOW (BANK 2) , Diagnostic Trouble Code (DTC) Detecting Criteria. >
TROUBLE SYMPTOM:
Erroneous idling
CAUTION:
After repair or replacement of faulty parts, perform Clear Memory Mode < Ref. to
OPERATION , Clear Memory Mode. > and Inspection Mode < Ref. to
PROCEDURE , Inspection Mode. >.
WIRING DIAGRAM:
DTC P0082 INTAKE VALVE CONTROL SOLENOID CIRCUIT LOW (BANK 2) - DIAGNOSTIC PROCEDURE
| Step | Check | Yes | No |
|---|---|---|---|
1 CHECK HARNESS BETWEEN ECM AND OIL SWITCHING SOLENOID VALVE.
|
Is the resistance less than 1 Ω? | Go to step 2. | Repair the open circuit of harness between ECM and oil switching solenoid valve connector.
NOTE:
In this case, repair the following item:
|
2 CHECK OIL SWITCHING SOLENOID VALVE.
|
Is the resistance between 6 and 12 Ω? | Repair the poor contact of ECM and oil switching solenoid valve. | Replace the oil switching solenoid valve. < Ref. to OIL SWITCHING SOLENOID VALVE . > |