LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different car >> Section 60 (Emission Control (Aux. Emission Control Devices) (H6DO)) >> Pressure Control Solenoid Valve >> Removal

Pressure Control Solenoid Valve: Removal

WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the vehicle on a lift.
  2. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G05019586
  3. Lift-up the vehicle.
  4. Disconnect connector (A) from the pressure control solenoid valve.
  5. Disconnect the evaporation hose (B) from the pressure control solenoid valve.
  6. Remove the bolts (C) which secure the bracket to the fuel tank.
    Fig 2: Identifying Connector, Evaporation Hose And Bolt
    G05016952
  7. Remove the pressure control solenoid valve from the bracket.
    Fig 3: Locating Pressure Control Solenoid Valve
    G05016953
scientia non olet · About LEMON Manuals