Knock Sensor: Installation
WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.
- Install the knock sensor to cylinder block.
Tightening torque: 25 N.m (2.5 kgf-m, 18 ft-lb)
NOTE: For the knock sensor installation angle, refer to the figure below. - Connect the knock sensor connector.
- Install the intake manifold. < Ref. to INSTALLATION , Intake Manifold. >
- Connect the battery ground cable to the battery.
- Install the collector cover.