LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Fuel Injection (Fuel Systems) (H6DO)) >> Fuel Sub Level Sensor >> Installation

Fuel Sub Level Sensor: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal.

NOTE:
  • Use a new gasket.
  • Make sure the sealing portion is free from fuel or foreign matter before installation.
  • Align the protrusion (A) of gasket with the position shown in the figure.
  • Align the protrusion (B) of fuel sub level sensor with the cutout on the upper plate of fuel sub level sensor.
  • Tighten the nuts and bolts to the specified torque in the order as shown in the figure.

Tightening torque: 4.4 N.m (0.45 kgf-m, 3.2 ft-lb) 

Fig 1: Identifying Tightening Sequence Of Fuel Sub Level Sensor Nuts And Bolts
G05016929
Fig 2: Locating Fuel Sub Level Sensor Nuts And Bolts
G05018575
scientia non olet · About LEMON Manuals