Fuel Pump: Inspection

WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.

Connect the lead harness to the connector terminal of fuel pump, and apply the battery power supply to check whether the pump operates.

WARNING:

Wipe off fuel completely.
Keep the battery as far apart from fuel pump as possible.
Be sure to turn the battery supply to ON and OFF on the battery side.
Do not run the fuel pump for a long time under non-load condition.

Fig 1: Applying Battery Power Supply To Fuel Pump Connector Terminal