Fuel Filler Pipe: Assembly

WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.

Install the shut pipe to the fuel filler pipe. < Ref. to INSTALLATION , Shut Valve. >
Tighten the nuts which secure the evaporation pipe assembly to the fuel filler pipe.
Tightening torque: 7.5 N.m (0.76 kgf-m, 5.5 ft-lb)

Fig 1: Locating Evaporation Pipe Assembly Holding Nut

Fig 2: Locating Evaporation Pipe Assembly Holding Nut
Connect the evaporation hose to the shut valve.

Fig 3: Locating Evaporation Hose