Oil Switching Solenoid Valve: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.

Install the oil switching solenoid valve holder.
NOTE: Always use new gaskets.
1. Temporarily tighten the bolts by tightening torque of 5 - 10 N.m (0.5 - 1.0 kgf-m, 3.7 - 7.4 ft-lb) in order shown in the figure.
2. Tighten the bolts by tightening torque of 10±0.5 N.m (1.0±0.05 kgf-m, 7.4±0.37 ft-lb) in order shown in the figure.
  
  Fig 1: Tightening Sequence Of Bolts
Install the oil temperature sensor.
< Ref. to INSTALLATION , Oil Temperature Sensor. >
Install the variable valve lift diagnosis oil pressure switch.
< Ref. to INSTALLATION , Variable Valve Lift Diagnosis Oil Pressure Switch. >
Install the oil switching solenoid valve.
Connect the connector to oil switching solenoid valve.

Fig 2: Identifying Oil Switching Solenoid Valve
Install the air intake chamber.
< Ref. to INSTALLATION , Air Intake Chamber. >