Crank Pulley: Installation

WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.

Install the crank pulley.
Install the crank pulley bolt. To lock the crankshaft, use ST.
ST 499977100 CRANK PULLEY WRENCH
1. Clean the crank pulley thread using compressed air.
2. Apply engine oil to the crank pulley bolt seat and thread.
3. Tighten the crank pulley bolts.
Tightening torque:

178 N.m (18.1 kgf-m, 131 ft-lb)

Fig 1: Locating Crank Pulley Bolts
Install the crank pulley cover.
NOTE: Assemble the O-ring to crank pulley cover.

Tightening torque:

6.4 N.m (0.65 kgf-m, 4.7 ft-lb)

Fig 2: Identifying Crank Pulley Cover