LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Intake (Induction) (H6DO)) >> Air Cleaner Element >> Removal

Air Cleaner Element: Removal

WARNING: This page is about a different car, the 2006 Subaru Outback. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G05019586
  2. Disconnect the connector from mass air flow and intake air temperature sensor.
    Fig 2: Locating Mass Air Flow And Intake Air Temperature Sensor Connector
    G05018452
  3. Remove the clip (A) securing upper side of air cleaner case.
    Fig 3: Locating Clip Securing Upper Side Of Air Cleaner Case
    G05018614
  4. Pull the air cleaner case (rear) backward of the vehicle, and remove the air cleaner element.
    NOTE: Be careful of the power steering hose fixed to the bottom of the air cleaner case (rear).