LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Intake (Induction) (H4DOTC) >> Air Cleaner Element >> Removal

Air Cleaner Element: Removal

  1. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G05019586
  2. Disconnect the connector (A) from the mass air flow sensor.
  3. Loosen the clamp (B) which connects the air intake boot and intake duct.
  4. Remove the clip (C) from the air cleaner case.
    Fig 2: Locating Air Cleaner Case Clip
    G05017972
  5. Remove the air cleaner case (rear) and air intake boot.
  6. Remove the air cleaner element.
scientia non olet · About LEMON Manuals