Front Exhaust Pipe: Installation

NOTE: Replace with a new gasket.

Install the front exhaust pipe and the exhaust manifold.
Tightening torque: 35 N.m (3.6 kgf-m, 26.0 ft-lb)

Fig 1: Identifying Front Exhaust Pipe And Exhaust Manifolds
Install the front exhaust pipe cover.
Tightening torque: 7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
Install the exhaust manifold upper cover (RH).
Tightening torque: 19 N.m (1.9 kgf-m, 13.7 ft-lb)
Install the front exhaust pipe assembly.
Tightening torque: 35 N.m (3.6 kgf-m, 26.0 ft-lb)
Connect the exhaust manifold (RH) to turbo-charger joint pipe.
Tightening torque:

T1: 35 N.m (3.6 kgf-m, 26.0 ft-lb)

T2: 40 N.m (4.0 kgf-m, 28.9 ft-lb)

Fig 2: Identifying Exhaust Manifold Nut Tightening Torque (1 Of 2)

Fig 3: Identifying Exhaust Manifold Nut Tightening Torque (2 Of 2)
Install the exhaust manifold lower cover (RH) and the exhaust manifold lower cover (LH).
Tightening torque: 19 N.m (1.9 kgf-m, 13.7 ft-lb)

Fig 4: Identifying Exhaust Manifold Lower Cover (RH) And Exhaust Manifold Lower Cover (LH)
Install the front oxygen (A/F) sensor.
< Ref. to INSTALLATION , Front Oxygen (A/F) Sensor. >
Install the under cover.
Connect the battery ground cable to the battery.

Fig 5: Connecting Battery Ground Cable To Battery