Read Diagnostic Trouble Code (DTC)

NOTE:

DTC is displayed in the sequence of inputting. (When entering two DTCs or more simultaneously, they are displayed in the sequence of priority.)
When more than two DTCs are displayed, perform the diagnosis of top one.

Prepare the Subaru Select Monitor kit.

Fig 1: Identifying Subaru Select Monitor Kit
Connect the diagnosis cable to the Subaru Select Monitor.
Insert the cartridge into the Subaru Select Monitor. < Ref. to SPECIAL TOOL , PREPARATION TOOL, General Description. >

Fig 2: Inserting Cartridge Into Subaru Select Monitor
Connect the Subaru Select Monitor to the data link connector.
The data link connector is located in the lower portion of the instrument panel (on the driver's side).

Fig 3: Identifying Data Link Connector

CAUTION: Do not connect the scan tools except for Subaru Select Monitor.
Turn the ignition switch to ON (engine OFF) and turn the Subaru Select Monitor switch ON.

Fig 4: Identifying Power Switch
On the «Main Menu» display screen, select {Each System Check} and press the [YES] key.
On the «System Selection Menu» display screen, select the {Integ. unit mode} and press the [YES] key.
On the «Integ. unit mode failure diag» display screen, select the {Diagnostic Code(s) Display} and press the [YES] key.
NOTE:
- For details concerning the operation procedures, refer to the "Subaru Select Monitor Operation Manual".
- For details concerning DTCs, refer to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .