LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine Mechanical (H4DOTC) >> V-belt >> Installation >> Rear Side Belt

Rear Side Belt

  1. Remove the A/C belt tensioner.
  2. Install the V belt, and tighten the slider bolt (B) to obtain the specified belt tension.

    < Ref. to INSPECTION , V-belt. >

  3. Tighten the lock nut (A).

    Tightening torque: 

    Lock nut (A): 22.6 N.m (2.3 kgf-m, 16.6 ft-lb) 

    Fig 1: Identifying Lock Nut And Slider Bolt
    G04998653
scientia non olet · About LEMON Manuals