LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Cooling System (Mechanical) >> Cooling System (H4DOTC) >> Radiator Sub Fan and Fan Motor >> Removal

Radiator Sub Fan and Fan Motor: Removal

  1. Remove the collector cover.
  2. Disconnect the ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G05019586
  3. Lift-up the vehicle.
  4. Remove the under cover.
  5. Disconnect the sub fan motor connector (B).
    Fig 2: Identifying Sub Fan Motor Connector (B)
    G05021456
  6. Remove the heat shield cover from radiator. (AT model)
    Fig 3: Locating Heat Shield Cover Bolt (AT Model)
    G05021454
  7. Drain the coolant about 1 l  (1.06 US qt, 0.88 Imp qt). < Ref. to DRAINING OF ENGINE COOLANT , REPLACEMENT, Engine Coolant. >
  8. Remove the ATF hose from the clip of the radiator sub fan motor assembly. (AT model)
  9. Lower the vehicle.
  10. Remove the air intake duct.
  11. Disconnect the over flow hose.
  12. Remove the over flow pipe.
  13. Remove the reservoir tank. < Ref. to REMOVAL , Reservoir Tank. >
  14. Remove the mounting bolts from the radiator sub fan motor assembly.
    Fig 4: Locating Radiator Sub Fan Motor Assembly Mounting Bolts
    G05021492
  15. Disconnect the radiator inlet hose (A) from the radiator.
  16. Remove the hood stay holder (B).
    Fig 5: Identifying Hood Stay Holder (B)
    G05021459
  17. Remove the radiator sub fan motor assembly from the vehicle.
scientia non olet · About LEMON Manuals