LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Accessory Drive Belts >> Engine Mechanical (H4DOTC) >> Cylinder Head >> Assembly

Cylinder Head: Assembly

Fig 1: Identifying Cylinder Head Components
G05018161
  1. Installation of valve spring and valve:
    1. Coat the stem of each valve with engine oil and insert the valve into valve guide.
      NOTE: When inserting the valve into valve guide, use special care not to damage the oil seal lip.
    2. Set the cylinder head on ST1.
    3. Install the valve spring and retainer using ST2.

      ST1 498267600 CYLINDER HEAD TABLE 

      ST2 499718000 VALVE SPRING REMOVER 

      NOTE: Be sure to install the valve spring with its close-coiled end facing the seat on cylinder head.
      Fig 2: Identifying Cylinder Head Table ST1 498267600 And Valve Spring Remover ST2 499718000
      G04998732
    4. Compress the valve spring and fit the valve spring retainer key.
    5. After installing, tap the valve spring retainers lightly with a wooden hammer for better seating.
  2. Apply oil to the surfaces of the valve lifter.
  3. Install the valve lifter.
scientia non olet · About LEMON Manuals