Wagon Model
- Fully close the glass lid (front) and glass lid (rear).
- Disconnect the ground cable from battery.
- Remove the luggage room light. < Ref. to ROOM LIGHT SWITCH , REMOVAL, Luggage Room Light. >
- Remove the roof trim. < Ref. to WAGON MODEL , REMOVAL, Roof Trim. >
- Pass the seat belt tongue located on the center of the rear seat through the hole, and then pull it out to the opposite side of the trim.
- Remove the clips, and let the rear end of the roof trim hang.
- Disconnect the harness connector (A), and then remove the motor assembly mounting bolts (B) and nut (C).