LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seats >> Rear Seat >> Disassembly >> (Wagon Model)

(Wagon Model)

  1. Remove the rear seat. < Ref. to (WAGON MODEL) , REMOVAL, Rear Seat. >
  2. Remove the hooks at the bottom of backrest assembly LH, and then turn over the backrest cover to remove the hog rings (A) and hooks (B).
    Fig 1: Identifying Hog Rings And Hooks
    G05022783
  3. Remove the hog rings (A) on the front side of backrest, and then remove the backrest cover.
    Fig 2: Identifying Front Side Backrest Hog Rings
    G05022784
  4. Remove the bolts, and then remove the backrest latch.
    Fig 3: Identifying Backrest Latch Bolts
    G05022785
  5. Loosen the screws to remove the armrest from backrest assembly RH.
    Fig 4: Identifying Backrest Assembly RH Screws
    G05022786
    NOTE: The armrests cannot be detached while the backrest assembly RH and armrest side pin positions are not aligned.
  6. After this operation, refer to the step  2) to disassemble the backrest assembly RH.
  7. Remove the hook, and then remove the armrest cover.
    Fig 5: Identifying Armrest Cover And Hook
    G05022779
  8. Remove the hook and hog ring, and then remove the headrest cover.
    Fig 6: Identifying Headrest Cover Hook And Hog Ring
    G05022780
  9. Remove the hog rings (A) on the rear side of the seat cushion.
    Fig 7: Identifying Rear Side Seat Cushion Hog Rings
    G05022781
  10. Remove the hog rings (A), then remove the seat cushion cover.
    Fig 8: Identifying Seat Cushion Cover Hog Rings
    G05022782
scientia non olet · About LEMON Manuals