LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Seats >> Seats >> Front Seat >> Removal >> Driver's Seat

Driver's Seat

  1. Remove the headrest.
  2. Tilt the backrest forward, and move the seat forward.
  3. Remove the rear bolt cover, and remove the two bolts at the rear side of the slide rail.
  4. Move the seat towards the rear, and remove the two bolts at the front side of the slide rail.
  5. Disconnect the ground cable from battery, and wait for more than 20 seconds before starting work.
  6. Disconnect the connector under the seat.
    • Seat belt buckle switch connector
    • Seat position sensor connector
    • Side airbag connector
    • Seat heater connector (model with seat heater)
    • Power seat connector (model with power seats)
  7. Remove the seat from vehicle.
scientia non olet · About LEMON Manuals