High Beam And Low Beam

CAUTION:

Because the halogen bulb operates at a high temperature, dirt and oil on the bulb surface reduces the bulb's service life. Hold the flange portion when replacing the bulb. Never touch the glass portion.
Do not leave the headlight without a bulb for a long time. Dust, moisture, etc. entering the headlight may affect its performance.

Disconnect the ground cable from battery.
Remove the air intake duct. (When removing the headlight bulb RH).

Fig 1: Locating Air Intake Duct Screws
Remove the battery cover. (When removing the headlight bulb LH)
Tilt the washer tank filler neck. (When removing the headlight bulb LH)
Disconnect the harness connector.
Remove the bulb assembly (A) then remove the high beam. To remove the low beam, remove the back cover (B), and then go to Step 7.

Fig 2: Identifying Bulb Assembly And Back Cover
Remove the light bulb retaining spring (A) to remove bulb.

Fig 3: Identifying Light Bulb Retaining Spring