LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Interior/Exterior Trim >> Exterior/Interior Trim >> Rear Shelf Trim >> Removal

Rear Shelf Trim: Removal

  1. Disconnect the ground cable from battery.
  2. Remove the rear quarter trim. < Ref. to SEDAN MODEL , REMOVAL, Rear Quarter Trim. >
  3. Remove the high-mounted stop light. < Ref. to REMOVAL , High-mounted Stop Light. >
  4. Remove the rear seat cushion. < Ref. to (WAGON MODEL) , REMOVAL, Rear Seat. >
  5. Remove the lower anchor bolt of the rear center seat belt.
    Fig 1: Identifying Lower Anchor Bolt Of Rear Center Seat Belt
    G05023033
  6. After disconnecting the high-mounted stop light harness connector (A) and removing the five clips, remove the rear shelf trim by pulling it forward.
    Fig 2: Identifying Rear Shelf Trim Clips
    G05023034
scientia non olet · About LEMON Manuals