LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Legacy GT spec.B >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Anti-Theft Systems >> Security And Locks >> Rear Door Latch and Door Lock Actuator Assembly >> Removal

Rear Door Latch and Door Lock Actuator Assembly: Removal

  1. Disconnect the ground cable from battery.
  2. Remove the rear door trim. < Ref. to REMOVAL , Door Trim. >
  3. Remove the cable from rear inner remote. < Ref. to REMOVAL , Rear Inner Remote. >
  4. Remove the sealing cover. < Ref. to REMOVAL , Rear Sealing Cover. >
  5. Remove the rear door glass. < Ref. to REMOVAL , Rear Door Glass. >
  6. Remove the rear sash. < Ref. to REMOVAL , Rear Regulator and Motor Assembly. >
  7. Pull out the cable from the cable clamp of the outer handle.
  8. Remove the three screws.
    Fig 1: Locating Rear Door Latch And Door Lock Actuator Assembly Screws
    G05022808
  9. Disconnect the connectors, and then remove the rear door latch and door lock actuator assembly.
scientia non olet · About LEMON Manuals