Stop Light Switch: Adjustment

Loosen the lock nut, and adjust the stop light switch position until the clearance A between threaded end of stop light switch and stopper becomes 0.3 mm (0.012 in). Then, tighten the lock nut.

Tightening torque:

8 N.m (0.8 kgf-m, 5.8 ft-lb)

Fig 1: Adjusting Stop Light Switch Position

Courtesy of SUBARU OF AMERICA, INC.

NOTE: Tighten the lock nut B until the clearance between threaded end of stop light switch and stopper becomes 0 mm (0 in). Hold the stop light switch to prevent turning, and then loosen the lock nut B approx. 60 degrees. The clearance will become 0.3 mm (0.012 in).