LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Forester X, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> Rear Brake Pad >> Installation

Rear Brake Pad: Installation

  1. Apply a thin coat of Molykote AS880N (Part No. K0777YA010) to the frictional portion between pad and pad clip.
    CAUTION: Replace the pad if there is oil or grease on it.
  2. Install the pad on support.
  3. Install the caliper body on support.

    Tightening torque: 

    37 N.m (3.8 kgf-m, 27.5 ft-lb) 

    NOTE: If it is difficult to push the piston during pad replacement, loosen air bleeder to facilitate work.
scientia non olet · About LEMON Manuals