LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Forester X, Standard >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brakes - Mechanical >> Hill Holder >> Removal >> PHV (Pressure Hold Valve)

PHV (Pressure Hold Valve)

  1. Drain the brake fluid from reservoir of master cylinder.
  2. Remove the adjusting nut and lock nut.
    Fig 1: Removing Adjusting Nut And Lock Nut
    G03808725Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the cable clamp, and disconnect the PHV cable from PHV.
    CAUTION: Carefully protect the boots and inner cable from damage when disconnecting PHV cable.
    Fig 2: Disconnecting PHV Cable From PHV
    G03808726Courtesy of SUBARU OF AMERICA, INC.
  4. Disconnect the brake pipes from PHV.
    CAUTION:
    • Pay attention not to drop the brake fluid onto body painting since it may dissolve paint.
    • Pay attention not to damage hexagonal head of the flare nut by using pipe wrench without fail.
  5. Detach the PHV along with support from side frame.
CAUTION: Exercise utmost care to prevent foreign matter from entering into the PHV when removing it.
Fig 3: Detaching PHV Along With Support From Side Frame
G03808727Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals