ATF Cooler Pipe and Hose: Installation

Install the oil cooler outlet and inlet pipes.
NOTE: Be sure to use a new aluminum washer.

Tightening torque:

T1: 40 N.m (4.1 kgf-m, 30 ft-lb)

T2: 44 N.m (4.5 kgf-m, 32.5 ft-lb)

T3: 25 N.m (2.5 kgf-m, 18.1 ft-lb)

Fig 1: Identifying Oil Cooler Outlet And Inlet Pipes
Courtesy of SUBARU OF AMERICA, INC.
Install ATF cooler pipe to frame.

Fig 2: Identifying ATF Cooler Pipe To Frame
Courtesy of SUBARU OF AMERICA, INC.
Connect ATF cooler hose to pipe transmission side.
NOTE:
- Install so that the hose is not folded over, excessively bent, or twisted.
- Be careful to insert the hose to the specified position.
  
  Fig 3: Identifying ATF Cooler Hose To Pipe Transmission Side
  Courtesy of SUBARU OF AMERICA, INC.
Connect ATF cooler hose to pipe of radiator side.
NOTE:
- Install so that the hose is not folded over, excessively bent, or twisted.
- Be careful to insert the hose to the specified position.
  
  Fig 4: Identifying ATF Cooler Hose To Pipe Of Radiator Side
  Courtesy of SUBARU OF AMERICA, INC.
Install the under cover.
Install battery and washer tank.
Fill ATF. < Ref. to AUTOMATIC TRANSMISSION FLUID . >
NOTE: Make sure there are no ATF leaks in joints between the transmission, radiator, pipes, and hoses.