LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Baja Turbo, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Fuel Injection (Fuel Systems) (H4SO)) >> Fuel Level Sensor >> Removal

Fuel Level Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
WARNING:
  • Place "NO FIRE" signs near the working area.
  • Be careful not to spill fuel on the floor.
NOTE: Fuel level sensor is built in fuel pump assembly.
  1. Remove fuel pump assembly. < Ref. to REMOVAL , FUEL PUMP. >
  2. Disconnect connector from fuel pump bracket.
    Fig 1: Disconnecting Connector From Fuel Pump Bracket
    G04988136Courtesy of SUBARU OF AMERICA, INC.
  3. Pushing the pawls with a screwdriver, remove fuel level sensor by pulling it downwards.
    NOTE: If the retainer pawls are broken during removal, the fuel level sensor must be replaced with a new one.
    Fig 2: Locating Fuel Level Sensor
    G04989276Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals