LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Baja Turbo, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Fuel Injection (Fuel Systems) (H4SO)) >> Crankshaft Position Sensor >> Removal

Crankshaft Position Sensor: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect ground cable from battery.
    Fig 1: Disconnecting Ground Cable From Battery
    G04988132Courtesy of SUBARU OF AMERICA, INC.
  2. Remove bolt which installs crankshaft position sensor to cylinder block.
    Fig 2: Identifying Crankshaft Position Sensor Bolt
    G04987842Courtesy of SUBARU OF AMERICA, INC.
  3. Remove crankshaft position sensor, and disconnect connector from it.
    Fig 3: Locating Crankshaft Position Sensor
    G04997386Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals