Transfer Driven Gear: Assembly

WARNING: This page is about a different variant/trim than selected.

Using the ST, install the roller bearing (extension case side).
ST1 398177700 INSTALLER

ST2 899864100 REMOVER

NOTE: Do not apply pressure in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton)

Fig 1: Installing Roller Bearing (Extension Case Side) Using Installer ST1398177700 And Remover ST2899864100
Courtesy of SUBARU OF AMERICA, INC.
Using the ST, install the roller bearing (transfer case side).
ST 499757002 INSTALLER

NOTE: Do not apply pressure in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton)

Fig 2: Installing Roller Bearing (Transfer Case Side) Using Installer ST499757002
Courtesy of SUBARU OF AMERICA, INC.