Transfer Drive Gear: Assembly

WARNING: This page is about a different variant/trim than selected.

Set the ST applying to inner race of bearing and install to drive shaft.
ST 398177700 INSTALLER

NOTE: Do not apply pressure in excess of 10 kN (1 ton, 1.1 US ton, 1.0 Imp ton)

Fig 1: Installing Inner Race Of Bearing Using Installer ST398177700
Courtesy of SUBARU OF AMERICA, INC.
Install the snap ring on transfer drive shaft.
Check the clearance between snap ring and ball bearing. < Ref. to INSPECTION , Transfer Drive Gear. >