LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Baja Turbo, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 18 (Manual Transmission And Differential) >> Shifter Fork and Rod >> Installation

Shifter Fork and Rod: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the reverse arm fork spring, ball and interlock plunger to reverse fork rod arm. Insert the reverse fork rod into hole in reverse fork rod arm, and hold it with outer snap ring using ST.
    NOTE: Apply grease to plunger to prevent it from falling.

    ST 399411700 ACCENT BALL INSTALLER

  2. Position the ball, spring and new gasket in reverse shifter rod hole, on left side transmission case, and tighten the checking ball plug.
  3. Install the 1-2 fork rod into 1-2 shifter fork via the hole on the rear of transmission case.
  4. Align the holes in rod and fork, and new drive straight pin into these holes using ST.
    NOTE:
    • Set other rods to neutral.
    • Make sure the interlock plunger is on the 3-4 fork rod side.

    ST 398791700 STRAIGHT PIN REMOVER

  5. Install the interlock plunger onto 3-4 fork rod.
    NOTE: Apply a coat of grease to plunger to prevent it from falling.
  6. Install the 3-4 fork rod into 3-4 shifter fork via the hole on the rear of transmission case.
  7. Align the holes in rod and fork, and new drive straight pin into these holes.
    NOTE:
    • Set the reverse fork rod to neutral.
    • Make sure the interlock plunger (installing before) is on the reverse fork rod side.

    ST 398791700 STRAIGHT PIN REMOVER

  8. Install the 5th shifter fork onto the rear of reverse fork rod. Align holes in the two parts and new drive straight pin into place.

    ST 398791700 STRAIGHT PIN REMOVER

    Fig 1: Identifying Straight Pin, Reverse Fork Rod And 5th Shifter Fork
    G04991038Courtesy of SUBARU OF AMERICA, INC.
  9. Position the balls, checking ball springs and new gaskets into 3-4 and 1-2 rod holes, and install plugs.

    Tightening torque: 

    20 N.m (2.0 kgf-m, 14.1 ft-lb) 

    Fig 2: Installing Plugs
    G05003147Courtesy of SUBARU OF AMERICA, INC.
  10. Install the differential assembly. < Ref. to INSTALLATION , FRONT DIFFERENTIAL ASSEMBLY. >
  11. Install the main shaft assembly.

    < Ref. to INSTALLATION , MAIN SHAFT ASSEMBLY. >

  12. Install the drive pinion shaft assembly. < Ref. to INSTALLATION , DRIVE PINION SHAFT ASSEMBLY. >
  13. Install the transmission case. < Ref. to INSTALLATION , Transmission Case. >
  14. Install the transfer case with extension case assembly. < Ref. to INSTALLATION , TRANSFER CASE AND EXTENSION CASE ASSEMBLY. >
  15. Install the back-up light switch and neutral position switch. < Ref. to INSTALLATION , SWITCHES AND HARNESS. >
  16. Install the manual transmission assembly to vehicle. < Ref. to INSTALLATION , Manual Transmission Assembly. >
scientia non olet · About LEMON Manuals