Reverse Check Sleeve: Disassembly

WARNING: This page is about a different variant/trim than selected.

Cover the reverse check sleeve with a rag, and remove the snap ring using a screwdriver.
NOTE: Replace the snap ring with a new one if deformed or weakened.

Fig 1: Identifying Snap Ring
Courtesy of SUBARU OF AMERICA, INC.
Remove the reverse check plate, reverse check spring, reverse check cam, return spring (5th-Rev), reverse accent shaft, return spring cap and return spring (1st-2nd).

Fig 2: Identifying Reverse Check Plate, Reverse Check Cam, Reverse Accent Shaft And Return Spring
Courtesy of SUBARU OF AMERICA, INC.
Remove the O-ring.
NOTE:
- Reverse check sleeve assembly uses an O-ring which should not be scratched.
- Be careful not to break the adjustment shim placed between reverse check sleeve assembly and case.