Neutral Position Adjustment
WARNING: This page is about a different variant/trim than selected.
- Shift the gear into 3rd gear position.
- Shifter arm turns lightly toward the 1st/2nd gear side but heavily toward the reverse gear side because of the function of return spring, until arm contacts the stopper.
- Make adjustment so that the heavy stroke (reverse side) is a little more than the light stroke (1st/ 2nd side).
- To adjust, remove the bolts holding reverse check sleeve assembly to the case, move the sleeve assembly outward, and place adjustment shim (0 to 1 ea.) between sleeve assembly and case to adjust the clearance.CAUTION: Be careful not to break the O-ring when placing shim(s).NOTE:
- When the shim is removed, the neutral position will move closer to reverse; when shim is added, the neutral position will move closer to 1st gear.
- If the shims alone cannot adjust clearance, replace the reverse accent shaft and re-adjust.
ADJUSTING SHIM THICKNESS SPECIFICATIONS
| Adjustment shim | |
|---|---|
| Part No. | Thickness mm (in) |
| 32190AA000 | 0.15(0.0059) |
| 32190AA010 | 0.30(0.0118) |
REVERSE ACCENT SHAFT REFERENCE
| Reverse accent shaft | ||
|---|---|---|
| Part No. | Mark | Remarks |
| 32188AA090 | 3 | Neutral position is closer to 1st gear. |
| 32188AA100 | 0 | Standard |
| 32188AA110 | 1 | Neutral position is closer to reverse gear. |