Reverse Idler Gear
WARNING: This page is about a different variant/trim than selected.
Adjustment of reverse idler gear position
Reverse idler gear to transmission case (LH) wall clearance
6.0 - 7.5 mm (0.236 - 0.295 in)
REVERSE SHIFTER LEVER REFERENCE
| Reverse shifter lever | ||
|---|---|---|
| Part No. | Mark | Remarks |
| 32820AA070 | 7 | Further from case wall |
| 32820AA080 | 8 | Standard |
| 32820AA090 | 9 | Closer to the case wall |
After installing a suitable reverse shifter lever, adjust the reverse idler gear to transmission case wall clearance to within 0 to 0.5 mm (0 to 0.020 in) using washers.
WASHER THICKNESS SPECIFICATIONS
| Washer (20.5 x 26 x t) | |||
|---|---|---|---|
| Part No. | Thickness mm (in) | Part No. | Thickness mm (in) |
| 803020151 | 0.4 (0.016) | 803020154 | 1.9(0.075) |
| 803020152 | 1.1 (0.043) | 803020155 | 2.3(0.091) |
| 803020153 | 1.5(0.059) | - | - |