HYPOID Gear Backlash

WARNING: This page is about a different variant/trim than selected.

Adjust backlash by turning the holder in right side case.

ST 499787000 WRENCH ASSY

Fig 1: Removing Differential Side Retainers Using Wrench Assy ST499787000

Courtesy of SUBARU OF AMERICA, INC.

NOTE: Each time holder rotates one tooth, backlash changes by 0.05 mm (0.0020 in).

Fig 2: Identifying Hypoid Gear Backlash

Courtesy of SUBARU OF AMERICA, INC.