LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Baja Turbo, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Automatic Transmission Diagnostics (4AT) (H4SO)) >> Subaru Select Monitor >> Operation >> Clear Memory Mode

Clear Memory Mode

WARNING: This page is about a different variant/trim than selected.
  1. On the « Main Menu» display screen, select the {2. Each System Check} and press the [YES] key.
  2. On the « System Selection Menu» display screen, select the {Transmission Control System} and press the [YES] key.
  3. Press the [YES] key after the information of transmission type is displayed.
  4. On the « Transmission Diagnosis» display screen, select the {Clear Memory} and press the [YES] key.
  5. When the "Done" and "Turn Ignition Switch OFF" are shown on display screen, turn the Subaru Select Monitor and ignition switch to OFF.
    NOTE: For detailed operation procedure, refer to the Subaru Select Monitor Operation Manual.
scientia non olet · About LEMON Manuals