LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Baja Turbo, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Clutch System) >> Release Bearing and Lever >> Removal

Release Bearing and Lever: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Remove the transmission assembly from vehicle body. < Ref. to REMOVAL , MANUAL TRANSMISSION ASSEMBLY. >
  2. Remove the two clips from clutch release lever and remove the release bearing.
    CAUTION: Be careful not to deform clips.
  3. Remove the dust cover.
    Fig 1: Identifying Clutch Release Lever And Dust Cover
    G04991063Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the retainer spring from pivot with a screwdriver by accessing it through release lever hole. Then remove the release lever.
    Fig 2: Removing Retainer Spring From Pivot
    G04991064Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals