LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Baja Turbo, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Clutch System) >> Release Bearing and Lever >> Installation

Release Bearing and Lever: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Before assembly, lubricate the following points with a coat of grease.
    • Contact surface of lever and pivot
    • Contact surface of lever and bearing
    • Transmission main shaft spline (Use grease containing molybdenum disulphide.)
    • Contact surface of lever and operating cylinder
  2. While pushing the fork to pivot and twisting it to both sides, fit the retainer spring onto the constricted portion of pivot.

    Apply grease (SUNLIGHT 2: P/N 003602010) to the contact point of release lever and operating cylinder.

  3. Confirm that the retainer spring is securely fitted by observing it through the release lever hole.
    Fig 1: Identifying Release Lever
    G04991065Courtesy of SUBARU OF AMERICA, INC.
  4. Install the release bearing and fasten it with two clips.
  5. Install the release lever dust cover.
    Fig 2: Identifying Clutch Release Lever And Dust Cover
    G04991066Courtesy of SUBARU OF AMERICA, INC.
  6. Verify that the bearing moves smoothly with operating release fork.
  7. Install the transmission assembly. < Ref. to INSTALLATION , MANUAL TRANSMISSION ASSEMBLY. >
scientia non olet · About LEMON Manuals