Master Cylinder: Disassembly

WARNING: This page is about a different variant/trim than selected.

Remove the straight pin and reservoir tank.

Fig 1: Identifying Straight Pin And Reservoir Tank
Courtesy of SUBARU OF AMERICA, INC.
Remove the oil seal.

Fig 2: Identifying Oil Seal And Master Cylinder
Courtesy of SUBARU OF AMERICA, INC.
Move the cylinder boot backward.

Fig 3: Moving Cylinder Boot Backward
Courtesy of SUBARU OF AMERICA, INC.
Remove the stop ring.
CAUTION: Be careful when removing the snap ring to prevent the rod, washer, piston and return spring from flying out.
Remove the clutch damper. (Turbo model)