Master Cylinder: Assembly

WARNING: This page is about a different variant/trim than selected.

Install the clutch damper. (Turbo model)
Tightening torque: 46.6 N.m (4.8 kgf-m, 34 ft-lb)
Apply a coat of grease to the contacting surfaces of the push rod and piston before installation.
Grease: SILICONE GREASE G40M (Part No. 004404003)

Fig 1: Applying Coat Of Grease To Contacting Surfaces Of Push Rod And Piston
Courtesy of SUBARU OF AMERICA, INC.
To assemble the master cylinder, reverse the sequence of disassembly procedure.
Tightening torque: 10 N.m (1.0 kgf-m, 7 ft-lb)