Turbo Model

WARNING: This page is about a different variant/trim than selected.

NOTE: Bleed air from the oil line with help of a co-worker.

Remove the intercooler. < Ref. to REMOVAL , INTERCOOLER (H4DOTC). >
Attach one end of a vinyl tube into the air bleeder of master cylinder and put the other end into a brake fluid container.
Slowly depress the clutch pedal and keep it. Then open the air bleeder to discharge air together with the fluid.
Release the air bleeder for 1 or 2 seconds. Next, with the bleeder closed, slowly release the brake pedal.

Fig 1: Releasing Air Bleeder
Courtesy of SUBARU OF AMERICA, INC.
Repeat the above steps until there are no more air bubbles in the vinyl tube.
CAUTION: Cover the bleeder with waste cloth when loosening it, to prevent brake fluid from being splashed over surrounding parts.
Tighten the air bleeder.
Tightening torque: 8 N.m (0.8 kgf-m, 5.8 ft-lb)
Fit one end of a vinyl tube into the air bleeder of operating cylinder and put the other end into a brake fluid container.

Fig 2: Identifying Clutch Hose And Air Bleeder
Courtesy of SUBARU OF AMERICA, INC.
Slowly depress the clutch pedal and keep it depressed. Then open the air bleeder to discharge air together with the fluid.
Release the air bleeder for 1 or 2 seconds. Next, with the bleeder closed, slowly release the clutch pedal.

Fig 3: Identifying Operating Cylinder And Vinyl Tube
Courtesy of SUBARU OF AMERICA, INC.
Repeat these steps until there are no more air bubbles in the vinyl tube.
CAUTION: Cover the bleeder with waste cloth when loosening it, to prevent brake fluid from being splashed over surrounding parts.
After depressing the clutch pedal, make sure that there are no leaks evident in the entire system.
After bleeding air from the system, ensure that the clutch operates properly.
Install the intercooler. < Ref. to INSTALLATION , INTERCOOLER (H4DOTC). >