Water Pump: Removal

WARNING: This page is about a different variant/trim than selected.

Disconnect ground cable from battery.

Fig 1: Disconnecting Ground Cable From Battery
Lift-up the vehicle.
Remove under cover.

Fig 2: Identifying Under Cover
Drain engine coolant completely.
< Ref. to DRAINING OF ENGINE COOLANT , REPLACEMENT, ENGINE COOLANT. >
Disconnect connectors from radiator main fan (A) and sub fan (B) motors.

Fig 3: Disconnecting Connectors From Radiator Main Fan And Sub Fan Motors
Disconnect radiator outlet hose and heater by pass hose from water pump.

Fig 4: Disconnecting Radiator Outlet Hose And Heater
Lower the vehicle.
Remove air intake duct.

Fig 5: Identifying Air Intake Duct
Disconnect overflow hose.

Fig 6: Disconnecting Overflow Hose
Remove reservoir tank.

Fig 7: Locating Reservoir Tank
Remove radiator main fan and sub fan assemblies. < Ref. to REMOVAL , RADIATOR MAIN FAN AND FAN MOTOR > and < Ref. to REMOVAL , RADIATOR SUB FAN AND FAN MOTOR. >
Remove V-belts.
< Ref. to REMOVAL , V-BELT. >
Remove timing belt.
< Ref. to TIMING BELT , REMOVAL, TIMING BELT. >
Remove automatic belt tension adjuster.

Fig 8: Removing Automatic Belt Tension Adjuster
Remove belt idler No. 2.

Fig 9: Identifying Belt Idler No. 2
Remove left-hand camshaft sprocket by using ST.
ST 18231AA010 CAMSHAFT SPROCKET WRENCH

NOTE: Camshaft sprocket wrench (499207100) is also available.

Fig 10: Removing Camshaft Sprocket By Using ST
Remove left-hand belt cover No. 2.

Fig 11: Locating Belt Cover No. 2 (LH) Bolts
Remove tensioner bracket.

Fig 12: Identifying Tensioner Bracket
Remove water pump.

Fig 13: Identifying Water Pump