Section 14 (Cooling System (H4SO)): Thermostat: Installation
WARNING: This page is about a different variant/trim than selected.
- Install the thermostat in the water pump, and install the thermostat cover together with a gasket.NOTE:
- Replace gasket with a new one.
- Thermostat must be installed with jiggle pin (A) facing the front side.
Tightening torque:
6.5 N.m (0.66 kgf-m, 4.8 ft-lb)
- Fill coolant. < Ref. to FILLING OF ENGINE COOLANT , REPLACEMENT, ENGINE COOLANT. >