Section 14 (Cooling System (H4SO)): Radiator: Removal
WARNING: This page is about a different variant/trim than selected.
- Disconnect battery ground cable.
- Lift-up the vehicle.
- Remove under cover.
- Drain engine coolant completely. < Ref. to DRAINING OF ENGINE COOLANT , REPLACEMENT, ENGINE COOLANT. >
- Disconnect connectors of radiator main fan (A) and sub fan (B) motor.
- Disconnect radiator outlet hose from thermostat cover.
- Disconnect ATF cooler hoses from radiator. (AT vehicles only)
- Lower the vehicle.
- Remove air intake duct.
- Disconnect overflow hose.
- Remove reservoir tank.
- Disconnect radiator inlet hose from engine.
- Remove radiator upper brackets.
- Detach power steering hose from the clip on the radiator.
- While slightly lifting radiator, slide it to left.
- Lift radiator up and away from vehicle.