Oil Pressure Switch: Installation

WARNING: This page is about a different variant/trim than selected.

Apply fluid packing to oil pressure switch threads.
Fluid packing:

Part No. 004403042

THREE BOND 1324 or equivalent

Fig 1: Applying Liquid Gasket To Oil Pressure Switch Threads
Courtesy of SUBARU OF AMERICA, INC.
Install oil pressure switch onto engine block.
Tightening torque:

25 N.m (2.5 kgf-m, 18.1 ft-lb)

Fig 2: Identifying Oil Pressure Switch
Courtesy of SUBARU OF AMERICA, INC.
Connect terminal of oil pressure switch.

Fig 3: Identifying Oil Pressure Switch
Courtesy of SUBARU OF AMERICA, INC.
Install generator on bracket. < Ref. to INSTALLATION , GENERATOR. >