Section 12 (Starting/Charging Systems (H4SO)): Generator: Inspection: Brush

WARNING: This page is about a different variant/trim than selected.

Measure the length of each brush. If wear exceeds the service limit, replace the brush. Each brush has the service limit mark (A) on it.
Brush length: Standard

18.5 mm (0.728 in)

Service limit

5.0 mm (0.197 in)

Fig 1: Identifying Brush Length Dimension
Courtesy of SUBARU OF AMERICA, INC.
Checking brush spring for proper pressure
Using a spring pressure indicator, push the brush into the brush holder until its tip protrudes 2 mm (0.08 in). Then measure the pressure of brush spring. If the pressure is less than 2.2 N (224 g, 7.91 oz), replace the brush spring with a new one. The new spring must have a pressure of 4.8 to 6.0 N (489 to 612 g, 17.26 to 21.60 oz).

Fig 2: Checking Brush Spring For Proper Pressure
Courtesy of SUBARU OF AMERICA, INC.