SUBARU Select Monitor (Normal Mode)

WARNING: This page is about a different variant/trim than selected.

On the «Main Menu» display screen, select the {Each System Check} and press the [YES] key.
On the «System Selection Menu» display screen, select the {Engine Control System} and press the [YES] key.
Press the [YES] key after displayed the information of engine type.
On the «Engine Diagnosis» display screen, select the {Diagnostic Code(s) Display} and press the [YES] key.
On the «Diagnostic Code(s) Display» display screen, select the {Current Diagnostic Code(s)} or {History Diagnostic Code(s)} and press the [YES] key.

NOTE:

For detailed operation procedure, refer to the Subaru Select Monitor Operation Manual.
For detailed concerning diagnostic trouble codes, refer to the LIST OF DIAGNOSTIC TROUBLE CODE (DTC) .
< Ref. to LIST OF DIAGNOSTIC TROUBLE CODE (DTC) . >