LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2006 >> Baja Turbo, Automatic >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Controls - Engine (Diagnostics) (H4SO)) >> Drive Cycle >> Operation >> Preparation For The Drive Cycle

Preparation For The Drive Cycle

WARNING: This page is about a different variant/trim than selected.
  1. Make sure that fuel remains approx. half amount [20 to 40 l  (5.3 - 10.6 US gal, 4.4 - 8.8 lmp gal)], and battery voltage is 12V or more.
  2. After performing diagnostics and cleaning the memory, check for any remaining unresolved trouble data. < Ref. to CLEAR MEMORY MODE . >
  3. Separate test mode connector.
NOTE:
  • Except for water temperature specified items at starting, diagnosis is carried out after engine warm up.
  • Carry out diagnosis which is marked * on DTC twice, Then, after finishing 1st diagnosis, stop engine and do the second time at the same condition.
scientia non olet · About LEMON Manuals