Drive Cycle A (After Running 20 Minutes At 80 Km/H (50 Mph), Idle Engine For 1 Minute.)
WARNING: This page is about a different variant/trim than selected.
DRIVE CYCLE DESCRIPTION
| DTC No. | Item | Condition |
|---|---|---|
| P0030 | HO2S Heater control circuit (Bank 1 Sensor 1) | - |
| *P0111 | Intake air temperature circuit range/performance | Coolant temperature at start is less than 30°C (86°F). |
| *P0125 | Insufficient coolant temperature for closed loop fuel control | Coolant temperature at start is less than 20°C (68°F). |
| *P0128 | Coolant thermostat (coolant temperature below thermostat regulating temperature) | Coolant temperature at start is less than 55°C (131°F). |
| *P0130 | O2 Sensor circuit (Bank 1 Sensor 1) | - |
| *P0133 | O2 Sensor circuit slow response (Bank 1 Sensor 1) | - |
| *P0420 | Catalyst system efficiency below threshold (Bank 1) | - |
| *P0442 | Evaporative emission control system leak detected (small leak) | - |
| *P0451 | Evaporative emission control system pressure sensor range/performance | - |
| P0453 | Evaporative emission control system pressure sensor high input | - |
| *P0456 | Evaporative emission control system leak detected (very small leak) | - |
| *P0457 | Evaporative emission control system leak detected (fuel cap loose/off) | - |
| *P0459 | Evaporative emission control system purge control valve circuit high | - |
| *P0464 | Fuel level sensor circuit intermittent | - |
| *P1137 | O2 Sensor circuit (Bank 1 Sensor 1) | - |
| P1443 | Vent control solenoid valve function problem | - |