DTC P0565 - Cruise Control On Signal -

WARNING: This page is about a different variant/trim than selected.

DTC DETECTING CONDITION:
- Two consecutive driving cycles with malfunction

CAUTION: After repair or replacement of malfunctioning parts, conduct Clear Memory Mode < Ref. to OPERATION , CLEAR MEMORY MODE > and INSPECTION MODE < Ref. to OPERATION , INSPECTION MODE. >

WIRING DIAGRAM:

Fig 1: Cruise Control Wiring Diagram
Courtesy of SUBARU OF AMERICA, INC.

DIAGNOSTIC PROCEDURE

Step	Check	Yes	No
1 CHECK HARNESS BETWEEN TCM AND CCM CONNECTOR. Turn ignition switch to OFF. Disconnect connectors from TCM and CCM. Measure resistance of harness between TCM and CCM connector. Connector & terminal (B54) No. 11 - (B94) No. 3:	Is the measured value less than 1 a?	Go to step 2.	Repair open circuit in harness between TCM and CCM connector.
2 CHECK HARNESS BETWEEN TCM AND CCM CONNECTOR. Measure resistance of harness between TCM and chassis ground. Connector & terminal (B55) No. 22 - Chassis ground: (with SPORT shift) (B54) No. 11 - Chassis ground: (without SPORT shift)	Is the measured value more than 1 MΩ?	Go to step 3.	Repair short circuit in harness between TCM and CCM connector.
3 CHECK INPUT SIGNAL FOR TCM. Connect connector to TCM and CCM. Lift-up the vehicle or set the vehicle on free rollers. CAUTION: On AWD models, raise all wheels off ground. Start the engine. Cruise control main switch to ON. Move selector lever to "D" and slowly increase vehicle speed to 50 km/h (31 MPH). Cruise control command switch to ON. Measure voltage between TCM and chassis ground. Connector & terminal (B54) No. 11 - Chassis ground:	Is the measured value less than 1 V?	Go to step 4.	Check cruise control command switch circuit. < Ref. to INSPECTION , CRUISE CONTROL COMMAND SWITCH. >
4 CHECK POOR CONTACT. Check poor contact in TCM connector.	Is there poor contact in TCM connector?	Repair poor contact in TCM connector.	Replace TCM. < Ref. to TRANSMISSION CONTROL MODULE (TCM) . >