DTC P0113 - Intake Air Temperature Circuit High Input -

WARNING: This page is about a different variant/trim than selected.

DTC DETECTING CONDITION:
- Detected simultaneously at occurrence of malfunction.
TROUBLE SYMPTOM:
- Erroneous idling
- Poor driving performance
CAUTION: After repair or replacement of malfunctioning parts, conduct Clear Memory Mode < Ref. to OPERATION , CLEAR MEMORY MODE > and INSPECTION MODE < Ref. to OPERATION , INSPECTION MODE. >
WIRING DIAGRAM:

Fig 1: Intake Air Temperature Wiring Diagram
Courtesy of SUBARU OF AMERICA, INC.

DIAGNOSTIC PROCEDURE

Step	Check	Yes	No
1 CHECK CURRENT DATA. Start engine. Read data of intake air temperature sensor signal using Subaru Select Monitor or the general scan tool. NOTE: Subaru Select Monitor For detailed operation procedure, refer to the "READ CURRENT DATA FOR ENGINE". < Ref. to SUBARU SELECT MONITOR . > General scan tool For detailed operation procedure, refer to the General Scan Tool Instruction Manual.	Is the measured value less than -40°C (-40°F)?	Go to step 2.	Repair poor contact. NOTE: In this case, repair the following: Poor contact in intake air temperature sensor Poor contact in ECM Poor contact in coupling connector Poor contact in joint connector
2 CHECK HARNESS BETWEEN INTAKE AIR TEMPERATURE SENSOR AND ECM CONNECTOR. Turn ignition switch to OFF. Disconnect connector from intake air temperature sensor. Measure voltage between intake air temperature sensor connector and engine ground. Connector & terminal (E20) No. 1 (+) - Engine ground (-):	Is the measured value more than 10 V?	Repair battery short circuit in harness between intake air temperature sensor and ECM connector.	Go to step 3.
3 CHECK HARNESS BETWEEN INTAKE AIR TEMPERATURE SENSOR AND ECM CONNECTOR. Turn ignition switch to ON. Measure voltage between intake air temperature sensor connector and engine ground. Connector & terminal (E20) No. 1 (+) - Engine ground (-):	Is the measured value more than 10 V?	Repair battery short circuit in harness between intake air temperature sensor and ECM connector.	Go to step 4.
4 CHECK HARNESS BETWEEN INTAKE AIR TEMPERATURE SENSOR AND ECM CONNECTOR. Measure voltage between intake air temperature and pressure sensor connector and engine ground. Connector & terminal (E20) No. 1 (+) - Engine ground (-):	Is the measured value more than 3 V?	Go to step 5.	Repair harness and connector. NOTE: In this case, repair the following: Open circuit in harness between intake air temperature sensor and ECM connector Poor contact in intake air temperature sensor Poor contact in ECM Poor contact in coupling connector Poor contact in joint connector
5 CHECK HARNESS BETWEEN INTAKE AIR TEMPERATURE SENSOR AND ECM CONNECTOR. Turn ignition switch to OFF. Measure resistance of harness between intake air temperature and pressure sensor connector and engine ground. Connector & terminal (E20) No. 2 - Engine ground:	Is the measured value less than 5 Ω?	Replace intake air temperature sensor. < Ref. to REMOVAL , INTAKE AIR TEMPERATURE SENSOR. >	Repair harness and connector. NOTE: In this case, repair the following: Open circuit in harness between intake air temperature sensor and ECM connector Poor contact in intake air temperature sensor Poor contact in ECM Poor contact in coupling connector Poor contact in joint connector